Zhengzhou FUJIE paste (add diluent to moderate the amount of solder paste according to deteriorate the situation, usually every add 2-3 drops of stir solder paste recycling prices, such as not enough to add 1-2 drops again, until with a spatula Paste blowing part, when the blade tilt, if the paste can smoothly slide, you can meet the requirements) of continuous printing, from time to time (based on availability) should be cleaned on the following stencils (steel mesh bottom or paste within a cell adhesion cleared to avoid blockage solder balls or mesh), attention must not be left in the water or other impurities in the solder paste and solder paste stencil printing is the most important of several cleaning parameter is the uniformity of the speed, blade speed, pressure, angle of blade, blade height and the overhead separating circuit board speed. Solder paste must be quoted thixotropic, which means declining teaching degree in the application process. Thixotropic paste solder paste with a special internal structure of prices which are subjected to mechanical action paste, when the recovery began when a shear force is removed, the internal structure is destroyed, this property can guarantee a good flow of solder paste circuit board. Paste quotes, FUJIE solder (certified), provided by the Zhengzhou City, Guizhou paste solder materials Limited Fujie. Zhengzhou City Fujie Soldering Materials Co., Ltd. (www.fujiehanxi.com) (www.fujiehanxi.com) is Zhengzhou, electronics, electrical products processing leader, over the years, the company implement the scientific management, innovation and development, the principle of honesty and trustworthiness , the maximum meet customer needs. In FUJIE solder leadership with the staff warmly welcome all inquiries negotiations to create FUJIE solder a better future.